Performance Optimized Wedge Enclosure | Fits Triple Kicker Solo X 8" Subwoofers Triple 8" Sealed enclosure

Yes. Each of the three baffle openings is CNC-cut to Kicker's published 7-5/16 inch cutout for the Solo X L7X 8, and every chamber clears the required 7-15/16 inch mounting depth with margin, including breathing room for the vented motors. Both coil versions fit; use three matched drivers.

Because chamber volume is non-negotiable. At 32 inches wide, the two internal dividers consume width that would otherwise be airspace, so the triple carries a slightly deeper profile, 11.75 inches at the top and 16 at the floor, to keep every chamber at the same 0.51 net cubic feet the single and dual use. Same Butterworth alignment per driver, just packaged to hold it three times over.

Yes, all three must match. The chambers are identical, so identical drivers wired identically share power evenly and stay in phase lockstep. Mixing coil versions off the single shared cup creates unequal branch impedances, splits power unevenly, and unbalances the set. Choose the coil version whose three-driver wiring lands at a load your amplifier is stable into: three dual 1-ohm drivers commonly net 0.67 or 6 ohms, three dual 2-ohm drivers net 1.33 ohms fully parallel.

Kicker recommends 400-800 watts RMS per Solo X 8, so plan 1200-2400 watts RMS of clean power across the trio at your wired impedance. The sealed chambers keep all three cones controlled as level climbs, so the top of that range is usable with properly set gains. One strong monoblock feeding the shared cup keeps the system simple.

Three 8s roughly match a 12 in cone area while spreading it across lighter, faster cones, and the cabinet stays 11.75 inches tall where our 12 wedge stands 15.25 and the 15 stands 18.25. The big singles still dig deeper anechoically with their lower F3s. The trio answers with transient speed, a wall-of-cone visual, and a height that works behind seats the big boxes cannot. If depth below 40 Hz is the priority, look at the 15 or 18; if speed, fit, and impact are, this is the one.

You need 32 inches of width, 11.75 inches of height, and 16 inches of depth at the floor; the top needs only 11.75 inches thanks to the 20 degree baffle rake, and the vertical rear panel sits flat against the cab wall. The height is friendly, the width is the thing to verify: measure the clear span behind your seat between belt towers and trim before ordering.

No, this listing is the enclosure only. It is built for three matched Kicker Solo X L7X 8s, which you install using the pressed 8/32 threaded inserts and the three sets of included stainless mounting hardware. If you want help sourcing a trio of Solo X 8s or matching an amplifier, call us at 931-563-5151.